2” X 2 ½” Base with a Full 2” Square Tool Head. Great for small and medium parts in the PE kits, including clamps, front and rear fenders, hinges, brackets, wire handles. Use all four sides of the tool-head never remove the knob, as the spring loaded tool head rotates easily. Swiss Comb edge for faster boxes, and Power Wedges for bending Thick Brass. 10 Micro-bending beams for Grab Handles in wire or flat brass Head & Base are machined from aircraft grade aluminum, instructions and folding blade included.
Three levels (1/16, 1/8, 1/4) to allow channel folding. Two sides are beveled for sharp folds to 135°. Cut-Outs reach into Photo Etch parts for complex folds. Very effective on large box/pan shapes. Excellent for any type or scale of Photo Etch less than 4″long Spring-loaded head rotate either face along the edge. Head & Base are machined from aircraft grade aluminum. Head hard anodized clear, base hard anodized black for excellent contrast. Instructions and small folding blade included. For more PE tools see the PE Tools section of the etoarmour.com site.
Dual Knobs gives flatter and higher pressure clamping ability needed on longer PE. 2 outer guide pins allow Pass-thru for long parts. 16 Bending Finger Options with longer fingers for deeper working area.
Secures parts up to 8″ long. Spring-loaded head rotate either face along the edge.Multi-position tool head for extra room on larger parts. Head & Base machined from aircraft grade aluminum. Hard anodized in contrasting clear & black Deep cut-outs for box shapes.Beveled base for folding longer and smaller grooves.Works on the smallest and largest PE detail parts. Handles Photo Etch in ANY Scale. 13 different folding finger sizes